ScopePar 1.0

ScopePar turns a PC into a multi-channel oscilloscope module utilizing the parallel port, the user interface to which is SeriCon on other PC. If you have an old PC, boot it by dos to run ScopePar and control it by SeriCon on your GUI PC through serial port. The free trial version of SeriCon is enough in usual cases. Important features are:

ScopePar is now a 5 channel square wave oscilloscope. Square waves mean that it just reads the high or low levels of the port pins (Later versions may be able to show curves, requiring ADC attached to the port). SeriCon shows only 2 channels, unless you have the full license.

Sampling rates around several 100kHz can be reached.

The measurement can be triggered by the first channel. You can select the level change (low-to-high or high-to-low).

The measurement can be automated by specifying the period of sending the command from SeriCon (with the full license).

PCWin Note: ScopePar 1.0 download version indexed from servers all over the world. There are inherent dangers in the use of any software available for download on the Internet. PCWin free download center makes no representations as to the content of ScopePar version/build 1.0 is accurate, complete, virus free or do not infringe the rights of any third party. PCWin has not developed this software ScopePar and in no way responsible for the use of the software and any damage done to your systems. You are solely responsible for adequate protection and backup of the data and equipment used in connection with using software ScopePar.

Category: Home & Education / Hobbies

Download | Homepage | Screenshot | Report Error